diff --git a/_locales/en/messages.json b/_locales/en/messages.json
index 31fbba3e..62475fbf 100755
--- a/_locales/en/messages.json
+++ b/_locales/en/messages.json
@@ -1152,7 +1152,7 @@
"message": "Warning"
},
"firmwareFlasherWarningText": {
- "message": "Please do not try to flash non-cleanflight hardware with this firmware flasher.
Do not disconnect the board or turn off your computer while flashing.
Note: STM32 bootloader is stored in ROM, it cannot be bricked.
Note: Auto-Connect is always disabled while you are inside firmware flasher.
Note: Make sure you have a backup; some upgrades/downgrades will wipe your configuration.
Note: If you have problems flashing try disconnecting all cables from your FC.
Note: If you have lost comminication with your board then power off the board, jumper the bootloader pins, power on, enable 'No reboot sequence', enable 'Full chip erase', re-flash, then power off, remove bootloader jumper, power on and connect (For all firmware except OPBL firmware)."
+ "message": "Please do not try to flash non-cleanflight hardware with this firmware flasher.
Do not disconnect the board or turn off your computer while flashing.
Note: STM32 bootloader is stored in ROM, it cannot be bricked.
Note: Auto-Connect is always disabled while you are inside firmware flasher.
Note: Make sure you have a backup; some upgrades/downgrades will wipe your configuration.
Note: If you have problems flashing try disconnecting all cables from your FC.
Note: If you have lost comminication with your board then power off the board, jumper the bootloader pins, power on, enable 'No reboot sequence', enable 'Full chip erase', re-flash, then power off, remove bootloader jumper, power on and connect."
},
"firmwareFlasherButtonLeave": {
"message": "Leave Firmware Flasher"